New test report: Audi A1 year 2018 ID48 key cloning done by Xhorse VVDI KEY TOOL remote maker.
*You should have Keytool ID48 96bit function activated and download Bluetooth app before operation.
Procedure:
Insert original remote into Keytool left coil to read key data
Select Transponder clone->Automatic detection
VVDI Key tool identify remote information: ID48, TP25 Audi
Remove key
Insert ID48 chip and read chip information
Connect VVDI Key Tool with mobile phone via Bluetooth
Select Transponder Clone function->ID48 data acquisition
Put VVDI Key Tool antenna close to ignition switch or coil detention area
Sniff data
If original key is not smart key, insert the original key, turn on ignition switch, then turn off, pull out the original key, repeat above procedure until sniff data completed.
If original key is not smart key, insert the original key, turn on ignition switch, then turn off, pull out the original key, repeat above procedure until sniff data completed.
If original key is smart key, take out the batter of original key, then put original key close to coil detection area and light up cluster turn off the ignition switch, move away the original key, repeat above procedure until completed.
Data acquisition success
Put the original key into the VVDI Key Tool left detection coil, to verify the original key
Read ID48 key data success
Then put the new ID48 chip, press Write button to write chip
Then put the new ID48 chip, press Write button to write chip
ID48 chip copy success.
Sync transponder key
New key works great.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.