Xhorse VVDI Tools, VVDI2, VVDI MB, VVDI Prog, VVDI key tool, VVDI BMW etc software & firmware download, update and technical support from vvdishop.com.
One of our customers has managed to read Mercedes Delphi CRD3.10 ECU with Xhorse Multi Prog.
Select MB Delphi CRD3x.x TC1797 protocol.
Boot is a different pinout. If your ECU is on service mode you need read in boot mode.
Pay attention to 2 resistors. 2x 1k resistor.
Multi prog will show you wiring diagram.
This is a Jeep control board with M95320 eeprom chip. We will show how to read this chip using Xhorse Multi Prog without laptop and PC software.
Connect M95320 EEPROM IC chip and Multiprog via a goog 8-pin clip adapter.
In multi prog, select Chip operation->M95XXX->M95320->Status
Read chip.
Read eeprom successfully. Then save data.
You can see file in Files folder.
You can save it to local to this or you can share it with you are connected to a Wi-Fi.
To program Isuzu D-Max 24C08 immobilizer keys you have to disassemble the immo box and read the data to calculate the password. Here we will show how to read immo data and pin code with xhorse vvdi prog.
Disassemble instrument cluster
Find Passive Entry and Start system module
Take out the inner circuit board and find the chip IC (24C08). This IC is a narrow-body chip, smaller than the common 8-pin one.
Read 24C08 data with xhorse vvdi prog programmer.
Find the password through the data. The password is directly displayed in the status area in reverse order. The actual password is 4043.
Then generate xhorse remote.
Program remote with OBD programmer with pin code.
How to find the key for 2023 Toyota Corolla Push with vvdi key tool max and XM38 Toyota?
Here is the clue.
Successfully generated Xhorse XM38 key with key tool max.
Use the Corolla 2561/1320 ID4A FCC ID HYQ14FBW option.
It works to lock and unlock the car, we modify the frequencies.
Trunk should be 09
Panic 10
Lock 01
Unlock 02
Frequencies should be like that. This is a perfect key. The key works just flawlessly. It starts the car.
If you guys ever need a 2023 Toyota Corolla this is how you’re going to generate that.
Here comes the solution to Xhorse multi prog BMW CAS3 chip crack failed problem.
Problem 1:
Read CAS3 0L15Y with multi prog, it says chip crack failed and asks to increase the voltage.
Problem 2:
Read and write a CAS3 from BMW 116 2007 model with multi prog…….. finally it manage to read and write (to remove ELV) but with problems. It starts reading the eeprom and it read it just fine, the tool works great with this… but when i start to read the flash, the tool couldn’t read it and suggested me to increase the voltage, I increase the voltage and the half of my attempt to read the mcu the multi prog couldn’t do it.
Solution:
Bad connections. You need to clean off the coating bmw put on the pcb board and then it will work.
You will get chip crack error if a pin isn’t making a perfect connection. You can use a special pen that removes the coating on it.
Multi prog reads with no problem. Do not connect XCLS screen and check connections one of the pins is incorrectly marked in the xhorse description.
If pin is correct, then try to increase voltage to 4-5V, try again.
You can also use the XDNP11GL CAS3 solder free adapter.
Feedback:
Done, one pin has bad connection. Redo every solder.
After reconnecting all needles tried again and succeeded.
