Problem:
Used Xhorse VVDI PROG and Sprinter(ST12) Benz EIS /EZS adapter to read chip data for sprinter 2006 W906 model, got error ” chip not found”.
Last time I red 2013 Sprinter fbs3, it failed neither.
I’ve tried Vito model perfect and W211 perfect.
vvdishop.com engineer solution:
If you have qualified welding skill, please try to weld instead of using the Sprinter(ST12) adapter.
Step1. Open VVDI PROG software. Choose “Type: 4-immobilizer”, “Brand: Benz” and “Chip: EIZ Sprinter (2015-)” then click on “Connection diagram”.
You can see the wiring diagram of EIS 0L01Y:
Step2. Click on “Read ID” then “Read”. VVDI-PROG read Mercedes W906 EIS 0L01Y OK!
Click on “Save” and name the file “ee”.
Step3. Click on “Flash” then “New” then “Read”.
Click on “Save” and name the file “flash”.
Step4. Click on “Erase” and “Yes” to confirm that.
After that, click on “Check Blank”.
Step5. Click on “Write” and “Yes” to confirm that.
Now you just need to wait about 3 minutes and Xhorse VVDIPROG write Mercedes W906 Sprinter EIS 0L01Y successfully!
Click “Verify” as the last step to check and things done!
Good luck.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.