7/27/2020

How to Solve Ford VCM II IDS V108 Application Error 27076

I have installed IDS V108 on Vmware to work with my Ford VCM II. When I run the software, I get the application error 27076 message “Ghost has detected corruption in the image file. Please perform an integrity check on the image…” is shown as below.




The possible cause:
Maybe there is something wrong with the file.

The solution:
Uninstall the current software and install by the following download link.
https://share.weiyun.com/5S508ie
Password: ynd37s
Security: Yes, it has been tested 100% ok by obdiitool.co.uk engineer.

Operating system: You’d better install Ford IDS V108 on Win7
Recommend WIN7 32bit system download link:
https://share.weiyun.com/59Noy7p
Password: 0awk7b

Computer operating system requirements:
1.If your computer hard drive only has one partition, please prepare a 16GB U flash drive
2.If has 2 partitions, please unzip the software into any other partition except disk C.

Note: If you don’t know how to download software from WeiYun, please refer to this article:
https://www.obdiitool.co.uk/info/how-to-download-software-from-weiyun.html

Guide to install Ford IDS V108 software for VCM2:
Extract Ford 108 software, delete the redundant files
Click on GHOST 8.0 to one key recovery

Restart computer
Click on Ford extending programming
Find VCI Manager (Ford-VCM-II) to install

If it prompts “PC software initialization error (getmoduletype), please go to Computer-> program files-> Ford motor company-> IDS-> Runtime-> install3rdparty-> ETAS-> setup

Install Bosch VCI Manager



When install successfully, run VCI Manager (Ford-VCM-II)
Connect VCMII to computer as below

Go to computer management-> Device manager->Network adapters to check whether the device connect successfully


Make sure the Internet connection is normal
Then you can run IDS 108 software
For the detailed operating steps, please watch the related video:


Tech support:
www.obdiitool.co.uk

Source:
http://blog.obdiitool.co.uk/solve-ford-vcm-ii-ids-v108-application-error/

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.