Before cloning Xhorse garage remote you should confirm the garage remote has been in deleted code status.
Check delete code status:
Before the remote cloning function, need to check the garage remote delete code status, make sure remote in deleted code status.
1. Delete code status: The LED will flash once then go out quickly when keep pressing any button of the garage remote.
2. Delete code operation:
Press and hold “Up” and “Down” of the garage remote at the same time, until LED turns on. Keep pressing 2 buttons until the LED light off, then release
the button.
Press and hold “Pause” until LED goes off. then released the button, Delete code successfully.
Remote Cloning
1. Preparation work before remote cloning
1). Confirm the garage temoe has been in deletecd code status.
2). Make sure the garage remote frequency is the same as the original remote, in case the remote cloning failed or even cloning is successful but the working distance too short, working not good occured.
2.Remote cloning operation
Press and hold any one button on Xhorse garage remote, this remote will eneter cloning mode, LED will flash once and then off. Keep pressing the button.
Press and hold the original remote one button (same button as step 1), put the original remote next to Xhorse garage remote. Once the LED turns on means correct button cloning successful.
Follow steps above to remote clone all buttons one by one.
Xhorse key tool, mini key tool, key tool max, key tool max pro, key tool plus can be used to clone garage remotes.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.